FS2101 datasheet(25/48 Pages) HP

25 / 48 page

The following error messages are reported by the PCI

inverse assembler.

ERROR-NO DEVICE SELECTED

This error is displayed during a non special cycle data phase

when IRDY and TRDY are asserted and DEVSEL is not

asserted.

ERROR DEVSEL ASSERTED

This error is displayed during a special cycle data phase if

DEVSEL is asserted.

SYSTEM ERROR

This error is displayed anytime SERR# is asserted.

The INVASM OPTIONS feature is not included with the PCI

Active Analysis Probe software. The same or better capability for

post processing acquired data can be achieved using the 16505A

Pattern Filters.

After the configuration file is loaded the PCI PC Mapper software

can be loaded:

Install the PCI Analysis Probe software flexible diskette

in the disk drive of the logic analyzer.

Configure the menu to “Load” the analyzer that is

connected to the PCI Active Analysis Probe with the file

names IAP64EXM.

Execute the load operation to load the file into the logic

analyzer.

Data can be acquired by touching the RUN button. As soon as

there is activity on the bus, the logic analyzer will begin to acquire

data. The analyzer will continue to acquire data and will display

the data when the analyzer memory is full, the trigger

specification is

TRUE or when you touch STOP.

The logic analyzer will flash “Slow or Missing Clock” if the PCI

Clock signal is not being detected by the logic analyzer. In this

case, check the logic analyzer to PCI Active Analysis Probe

connection (refer to your User’s Manual).

Error Messages

INVASM OPTIONS

Setting up the

Analyzer to use the

PC Mapper Inverse

Assembler

Acquiring Data

FS2101 bảng dữ liệu(PDF) 25 Page - Agilent(Hewlett-Packard)