FS2101 datasheet(37/48 Pages) HP

37 / 48 page

0 to 33Mhz PCI clock for State mode and 0-100Mhz for Timing

Mode.

The PCI Active Analysis Probe logic analyzer interface presents

only one electrical load on each PCI bus signal. However, the

extender card connector is an additional 4 inches beyond the

maximum allowed stub length.

All PCI Local Bus operations supported.

Operating:0 to 55 degrees C (+32 to +131 degrees F)

Non operating:-40 to +75 degrees C (-40 to +167 degrees F)

Operating: 4,6000m (15,000 ft)

Non operating: 15,3000m (50,000 ft)

Up to 90% non condensing. Avoid sudden, extreme temperature

changes which would cause condensation on the Analysis Probe

module.

There are no automatic performance tests or adjustments for the

PCI Active Analysis Probe module. If a failure is suspected in the

PCI Active Analysis Probe module contact the factory or your

FuturePlus Systems authorized distributor.

The repair strategy for the PCI Active Analysis Probe is module

replacement. However, if parts of the PCI Active Analysis Probe

module are damaged or lost contact the factory for a list of

replacement parts.

Minimum Clock Period

(State)

Signal loading

Operations

Environmental

Temperature

Altitude

Humidity

Testing and

Troubleshooting

Servicing

FS2101 bảng dữ liệu(PDF) 37 Page - Agilent(Hewlett-Packard)