ADP1763WACPZ-R7 datasheet(13/22 Pages) AD

13 / 22 page

Data Sheet

ADP1763

THEORY OF OPERATION

analog.com

Rev. E | 13 of 22

Figure 26. Adjustable VOUT Ramp-Up with External Soft Start Capacitor

(VOUT, EN) vs. Time

ADJUSTABLE OUTPUT VOLTAGE

The output voltage of the ADP1763 can be set over a 0.5 V to 1.5 V

range. Connect a resistor (RADJ) from the VADJ pin to ground to set

the output voltage. To calculate the output voltage, use the following

equation:

VOUT=AD× RADJ×IADJ

(3)

where:

AD is the gain factor with a typical value of 3.0 between the VADJ

pin and the VOUT pin.

IADJ is the 50.0 µA constant current out of the VADJ pin.

ENABLE FEATURE

The ADP1763 uses the EN pin to enable and disable the VOUT

pins under normal operating conditions. As shown in Figure 27,

when a rising voltage on EN crosses the active threshold, VOUT

turns on. When a falling voltage on EN crosses the inactive thresh-

old, VOUT turns off.

Figure 27. Typical EN Pin Operation

As shown in Figure 28, the EN pin has hysteresis built in. This

hysteresis prevents on/off oscillations that can occur due to noise

on the EN pin as it passes through the threshold points.

Figure 28. Output Voltage vs. Typical EN Pin Voltage, VOUT = 1.3 V

POWER-GOOD (PG) FEATURE

The ADP1763 provides a power-good pin (PG) to indicate the

status of the output. This open-drain output requires an external

pull-up resistor that can be connected to VIN or VOUT. If the device

is in shutdown mode, current-limit mode, or thermal shutdown, or

if it falls below 90% of the nominal output voltage, PG immediately

transitions low. During soft start, the rising threshold of the power-

good signal is 95% of the nominal output voltage.

The open-drain output is held low when the ADP1763 has sufficient

input voltage to turn on the internal PG transistor. An optional soft

start delay can be detected. The PG transistor is terminated via a

pull-up resistor to VOUT or VIN.

Power-good accuracy is 92.5% of the nominal regulator output

voltage when this voltage is rising, with a 95% trip point when this

voltage is falling.

Regulator input voltage brownouts or glitches trigger a power no

good if VOUT falls below 92.5%.

A normal power-down triggers a power good when VOUT is at 95%.

ADP1763WACPZ-R7 bảng dữ liệu(PDF) 13 Page - Analog Devices

ADP1763WACPZ-R7 bảng dữ liệu(HTML) 13 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

bảng dữ liệu tải về

Link URL