| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
PPC440GX-3RF800C bảng dữ liệu(PDF) 57 Page - Applied Micro Circuits Corporation |
|
|
|||||||||||||||||||||||||||||
PPC440GX-3RF800C bảng dữ liệu(HTML) 57 Page - Applied Micro Circuits Corporation |
|
57 / 93 page ![]() 440GX – Power PC 440GX Embedded Processor AMCC 57 Revision 1.15 – August 30, 2007 Data Sheet Trace Interface TrcBS0:2 Trace branch execution status. I/O 3.3V LVTTL TrcClk Trace data capture clock, runs at 1/4 the frequency of the processor. O 3.3V LVTTL TrcES0:4 Trace Execution Status is presented every fourth processor clock cycle. I/O 3.3V LVTTL TrcTS0:5 (multiplexed with GPIO signals) Additional information on trace execution and branch status. Note:The trace signals, TrcTS0:6, are duplicated on two sets of chip balls and are multiplexed with other signals in both cases. This allows users to choose which set of multiplexed signals they wish to use along with the TrcTS0:6 signals. The trace signals in this set are primary signals. I/O 3.3V tolerant 2.5V CMOS TrcTS1:5 (multiplexed with EBC signals) Additional information on trace execution and branch status. Note:The trace signals in this set are secondary signals. I/O 3.3V LVTTL TrcTS6 (multiplexed with EBC and Ethernet signals) Additional information on trace execution and branch status. Note:This trace signal is the primary signal. I/O 3.3V LVTTL Power Pins AGND PLL (analog) voltage ground. na na GND Ground. na na AxVDD 1.5V—Filtered voltages input for PLLs (analog circuits) Note: A separate filter for each of the three voltages is recommended. na na OVDD 3.3V supply—I/O (except DDR SDRAM, Ethernet) na na SVDD 2.5V supply—DDR SDRAM, Ethernet na na VDD 1.5V supply—Logic voltage. na na Signal Functional Description (Sheet 8 of 8) Notes: 1. Receiver input has hysteresis 2. Must pull up (recommended value is 3k Ω to 3.3V) 3. Must pull down (recommended value is 1k Ω) 4. If not used, must pull up (recommended value is 3k Ω to 3.3V) 5. If not used, must pull down (recommended value is 1k Ω) 6. Strapping input during reset; pull-up or pull-down required Signal Name Description I/O Type Notes |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |