PPC440GP-3CC466C datasheet(70/83 Pages) AMCC

70 / 83 page

440GP – Power PC 440GP Embedded Processor

AMCC

Revision 1.07 – October 4, 2007

Data Sheet

DDR SDRAM I/O Specifications

The DDR SDRAM controller times its operation with internal PLB clock signals and generates MemClkOut0 from

the PLB clock. The PLB clock is an internal signal that cannot be directly observed. However MemClkOut0 is the

same frequency as the PLB clock signal and is in phase with the PLB clock signal.

Note: MemClkOut0 can be advanced with respect to the PLB clock by means of the SDRAM0_CLKTR program-

ming register. In a typical system, users advance MemClkOut by 90

°. This depends on the specific applica-

tion and requires a thorough understanding of the memory system in general (refer to the DDR SDRAM

controller chapter in the PowerPC 440GP User’s Manual).

In the following sections, the label MemClkOut0(0) refers to MemClkOut0 when it has not been phase-shifted, and

MemClkOut0(90) refers to MemClkOut0 when it has been phase-advanced 90

°. Advancing MemClkOut0 by 90°

creates a 3/4 cycle setup time and 1/4 cycle hold time for the address and control signals in relation to

MemClkOut0(90). The rising edge of MemClkOut0(90) aligns with the first rising edge of the DQS signal.

The following DDR data is generated by means of simulation and includes logic, driver, package RLC, and lengths.

Values are calculated over best case and worst case processes with speed, temperature, and voltage as follows:

Best Case = Fast process, -40

°C, +1.9V

Worst Case = Slow process, +85

°C, +1.7V

Note: In all the following DDR tables and timing diagrams, the maximum values are measured under worst case

conditions. The minimum values (best case) are estimates based on comparable timing in a similar chip of a differ-

ent technology.

The signals are terminated as indicated in the figure below for the DDR timing data in the following sections.

DDR SDRAM Simulation Signal Termination Model

10pF

MemClkOut0

120

Addr/Ctrl/Data/DQS

VTT = SVDD/2

PPC440GP

10pF

Note: This diagram illustrates the model of the DDR SDRAM interface used when generating simulation timing data.

It is not a recommended physical circuit design for this interface. An actual interface design will depend on many

factors, including the type of memory used and the board layout.

PPC440GP-3CC466C bảng dữ liệu(PDF) 70 Page - Applied Micro Circuits Corporation