ST72324BJ2 datasheet(107/188 Pages) STMICROELECTRONICS

107 / 188 page

ST72324B

On-chip peripherals

107/188

Transmitter

The transmitter can send data words of either 8 or 9 bits depending on the M bit status.

When the M bit is set, word length is 9 bits and the 9th bit (the MSB) has to be stored in the

T8 bit in the SCICR1 register.

Character transmission

During an SCI transmission, data shifts out LSB first on the TDO pin. In this mode, the

SCIDR register consists of a buffer (TDR) between the internal bus and the transmit shift

Procedure

Select the M bit to define the word length.

Select the desired baud rate using the SCIBRR and the SCIETPR registers.

Set the TE bit to assign the TDO pin to the alternate function and to send a idle frame

as first transmission.

Access the SCISR register and write the data to send in the SCIDR register (this

sequence clears the TDRE bit). Repeat this sequence for each data to be transmitted.

Clearing the TDRE bit is always performed by the following software sequence:

An access to the SCISR register

A write to the SCIDR register

The TDRE bit is set by hardware and it indicates:

●

The TDR register is empty.

●

The data transfer is beginning.

●

The next data can be written in the SCIDR register without overwriting the previous

data.

This flag generates an interrupt if the TIE bit is set and the I bit is cleared in the CCR

When a transmission is taking place, a write instruction to the SCIDR register stores the

data in the TDR register and which is copied in the shift register at the end of the current

transmission.

When no transmission is taking place, a write instruction to the SCIDR register places the

data directly in the shift register, the data transmission starts, and the TDRE bit is

immediately set.

When a frame transmission is complete (after the stop bit) the TC bit is set and an interrupt

ST72324BJ2 bảng dữ liệu(PDF) 107 Page - STMicroelectronics