| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
7200 bảng dữ liệu(PDF) 32 Page - Arista Networks, Inc |
|
|
|||||||||||||||||||||||||||||
7200 bảng dữ liệu(HTML) 32 Page - Arista Networks, Inc |
|
32 / 44 page ![]() Label Port Number Port Type EOS Interface 1, 2, 3, 4 RJ45 Et1/1, Et1/2, Et1/3, Et1/4 1 3FTW, 4FTW Fail-to-wire 2 5, 6, 7, 8 SFP+ Et1/5, Et1/6, Et1/7, Et1/8 3 Slot 2, Slot 3 Network Interface Module (NIM) Interface Capabilities This section describes interface capabilities like speed and Forward Error Correction (FEC). For additional information, see the EOS User's Guide. These capabilities are displayed with the following command: show interfaces <INTF> hardware default The speed/auto-negotiation depends on the MAC/P-capabilities, the front panel connector, and the type of transceiver inserted. The default capabilities of the Arista AWE-7230R-4TX-4S Enterprise WAN router are as follows: Ports Speed Auto-negotiation RJ45 (Et1/1-Et1/4) 1G/2.5G/5G/10G full duplex 1G/2.5G/5G/10G full duplex SFP (Et1/5-Et1/8) 1G/10G 1G/10G full duplex 1G full duplex When a transceiver is inserted, EOS recognizes the transceiver type. To see which types of transceivers are supported, refer to the Supported Transceivers. EOS decides the capable speed/auto-negotiation that both the hardware and the modules satisfy. To view the show commands and example outputs, refer to the Show Commands for Speed and Auto-negotiation Capabilities. When the interface does not have a speed configuration, EOS applies the default speed. On an RJ45 port, the default configuration is auto-negotiation enabled with 10G. On an SFP port, the default configuration is auto-negotiation disabled with 10G. Speed Configuration This section describes the configuration of interface speed and auto-negotiation. Interface speed and auto-negotiation are configured using the speed speed-lane-token command, as shown in the following examples: To configure 10G speed with auto-negotiation disabled: Arista(config-if-Et1/1)# speed 10g To configure 1G speed with auto-negotiation disabled: Arista(config-if-Et1/1)# speed 1g To configure 10G speed with auto-negotiation enabled: 28 |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |