XRT83SL314IB datasheet(17/83 Pages) EXAR

17 / 83 page

XRT83SL314

14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT

REV. 1.0.1

1.0

CLOCK SYNTHESIZER

In system design, fewer clocks on the network card could reduce noise and interference. Common clock

references such as 8kHz are readily available to network designers. Network cards that support both T1 and

E1 modes must be able to produce 1.544MHz and 2.048MHz transmission data. The XRT83SL314 has a built

in clock synthesizer that requires only one input clock reference by programming CLKSEL[3:0] in the

appropriate global register. A list of the input clock options is shown in Table 1.

The single input clock reference is used to generate multiple timing references. The first objective of the clock

synthesizer is to generate 1.544MHz and 2.048MHz for each of the 14 channels. This allows each channel to

operate in either T1 or E1 mode independent from the other channels. The state of the equalizer control bits in

the appropriate channel registers determine whether the LIU operates in T1 or E1 mode. The second objective

is to generate additional output clock references for system use. The available output clock references are

shown in Figure 2.

TABLE 1: INPUT CLOCK SOURCE SELECT

CLKSEL[3:0]

INPUT CLOCK REFERENCE

0h (0000)

2.048 MHz

1h (0001)

1.544MHz

2h (0010)

8 kHz

3h (0011)

16 kHz

4h (0100)

56 kHz

5h (0101)

64 kHz

6h (0110)

128 kHz

7h (0111)

256 kHz

8h (1000)

4.096 MHz

9h (1001)

3.088 MHz

Ah (1010)

8.192 MHz

Bh (1011)

6.176 MHz

Ch (1100)

16.384 MHz

Dh (1101)

12.352 MHz

Eh (1110)

2.048 MHz

Fh (1111)

1.544 MHz

XRT83SL314IB bảng dữ liệu(PDF) 17 Page - Exar Corporation

XRT83SL314IB bảng dữ liệu(HTML) 17 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

bảng dữ liệu tải về

Link URL