NAND02G-B2C datasheet(17/62 Pages) STMICROELECTRONICS

17 / 62 page

NAND01G-B2B, NAND02G-B2C

Bus operations

17/62

Bus operations

There are six standard bus operations that control the memory. Each of these is described

in this section, see Table 5: Bus Operations, for a summary.

Typically, glitches of less than 5 ns on Chip Enable, Write Enable and Read Enable are

ignored by the memory and do not affect bus operations.

4.1

Command Input

Command Input bus operations are used to give commands to the memory. Commands are

accepted when Chip Enable is Low, Command Latch Enable is High, Address Latch Enable

is Low and Read Enable is High. They are latched on the rising edge of the Write Enable

signal.

Only I/O0 to I/O7 are used to input commands.

See Figure 19 and Table 24 for details of the timings requirements.

4.2

Address Input

Address Input bus operations are used to input the memory addresses. Four bus cycles are

required to input the addresses for 1Gb devices whereas five bus cycles are required for the

2Gb device (refer to Table 6 and Table 7, Address Insertion).

The addresses are accepted when Chip Enable is Low, Address Latch Enable is High,

Command Latch Enable is Low and Read Enable is High. They are latched on the rising

edge of the Write Enable signal. Only I/O0 to I/O7 are used to input addresses.

See Figure 20 and Table 24 for details of the timings requirements.

4.3

Data Input

Data Input bus operations are used to input the data to be programmed.

Data is accepted only when Chip Enable is Low, Address Latch Enable is Low, Command

Latch Enable is Low and Read Enable is High. The data is latched on the rising edge of the

Write Enable signal. The data is input sequentially using the Write Enable signal.

See Figure 21 and Table 24 and Table 25 for details of the timings requirements.

4.4

Data Output

Data Output bus operations are used to read: the data in the memory array, the Status

Data is output when Chip Enable is Low, Write Enable is High, Address Latch Enable is Low,

and Command Latch Enable is Low. The data is output sequentially using the Read Enable

signal.

See Figure 22 and Table 25 for details of the timings requirements.

NAND02G-B2C bảng dữ liệu(PDF) 17 Page - STMicroelectronics