CDB5378 datasheet(25/72 Pages) CIRRUS

25 / 72 page

CDB5378

DS639DB3

2.3.3

Digital Control Signals

The reset, synchronization and timebreak signals to the CS5378 digital filter can be generated by push

buttons, received from external inputs or generated by the on-board microcontroller. By default, the mi-

crocontroller reset (CPLD0_MC), push button SYNC_PB and push button TIMEB_PB signals are con-

nected through the interface CPLD to the CS5378 digital filter RESETz, SYNC and TIMEB inputs.

A four-position DIP switch on CDB5378 (S5) sets static digital control signals not normally changed during

operation. The LPWR signal (S5, #2) reduces the power consumption of the analog components at the

expense of analog performance. The PWDN signal (S5, #3) disables the analog components by placing

them in a micropower sleep state.

2.3.4

Microcontroller

Included on CDB5378 is an 8051-type microcontroller with integrated hardware SPI and USB interfaces.

This C8051F320 microcontroller is a product of Silicon Laboratories (http://www.silabs.com). Key features

of the C8051F320 microcontroller are:

8051 compatibility - uses industry-standard 8051 software development tools

In-circuit debugger - software development on the target hardware

Internal memory - 16k flash ROM and 2k static RAM included on-chip

Multiple serial connections - SPI, USB, I2C, and UART

High performance - 25 MIPS maximum

Low power - 0.6 mA @ 1 MHz w/o USB, 9 mA @ 12 MHz with USB

Small size - 32 pin LQFP package, 9mm x 9mm

Industrial temperature - full performance (including USB) from -40 C to +85 C

Internal temperature sensor - with range violation interrupt capability

Internal timers - four general purpose plus one extended capability

Power on reset - can supply a reset signal to external devices

Analog ADC - 10 bit, 200 ksps SAR with internal voltage reference

Analog comparators - arbitrary high/low voltage compare with interrupt capability

The exact use of these features is controlled by embedded firmware.

C8051F320 has dedicated pins for power and the USB connection, plus 25 general-purpose I/O pins that

connect to the various internal resources through a programmable crossbar. Hardware connections on

CDB5378 limit how the blocks can operate, so the port mapping of microcontroller resources is detailed

below.

CDB5378 bảng dữ liệu(PDF) 25 Page - Cirrus Logic