STR91XF datasheet(45/72 Pages) STMICROELECTRONICS

45 / 72 page

STR91xF

Memory mapping

45/72

Notes for Figure 9: STR91xx memory map on page 46:

Notes: 1 Either of the two Flash memories may be placed at CPU boot address 0x0000.0000. By default,

the primary Flash memory is in boot position starting at CPU address 0x0000.0000 and the

secondary Flash memory may be placed at a higher address following the end of the primary

Flash memory. This default option may be changed using the STR91xx device configuration

software, placing the secondary Flash memory at CPU boot location 0x0000.0000, and then

the primary Flash memory may be placed at a higher address.

2 The local SRAM (64KB or 96KB) is aliased in three address windows. A) At 0x0400.0000 the

SRAM is accessible through the CPU’s D-TCM, at 0x4000.0000 the SRAM is accessible

through the CPU’s AHB in buffered accesses, and at 0x5000.0000 the SRAM is accessible

through the CPU’s AHB in non-buffered accesses. An AHB bus master other than the CPU can

access SRAM in all three aliased windows, but these accesses are always non-buffered. The

CPU is the only AHB master that can performed buffered writes.

3 APB peripherals reside in two AHB-to-APB peripheral bridge address windows, APB0 and

APB1. These peripherals are accessible with buffered AHB access if the CPU addresses them

in the address range of 0x4800.0000 to 0x4FFF.FFFF, and non-buffered access in the address

range of 0x5800.0000 to 0x5FFF.FFFF.

4 Individual peripherals on the APB are accessed at the listed address offset plus the base

address of the appropriate AHB-to-APB bridge.

STR91XF bảng dữ liệu(PDF) 45 Page - STMicroelectronics