MCF5373CAB180 datasheet(17/42 Pages) FREESCALE

17 / 42 page

Preliminary Electrical Characteristics

MCF5373 ColdFire® Microprocessor Data Sheet, Rev. 0.3

Preliminary

Freescale Semiconductor

5.4.1

PLL Power Filtering

To further enhance noise isolation, an external filter is strongly recommended for PLL analog VDD pins.

The filter shown in Figure 6 should be connected between the board VDD and the PLLVDD pins. The

resistor and capacitors should be placed as close to the dedicated PLLVDD pin as possible.

Figure 6. System PLL VDD Power Filter

5.4.2

USB Power Filtering

To minimize noise, external filters are required for each of the USB power pins. The filter shown in

Figure 7 should be connected between the board EVDD or IVDD and each of the USBVDD pins. The

resistor and capacitors should be placed as close to the dedicated USBVDD pin as possible.

Input Leakage Current

Vin = VDD or VSS, Input-only pins

Iin

-1.0

1.0

µA

CMOS Output High Voltage

IOH = –5.0 mA

EVOH

EVDD - 0.4

—

CMOS Output Low Voltage

IOL = 5.0 mA

EVOL

—0.4

DDR/Bus Output High Voltage

IOH = –5.0 mA

SDVOH

SDVDD - 0.4

—

DDR/Bus Output Low Voltage

IOL = 5.0 mA

SDVOL

—0.4

Weak Internal Pull-Up Device Current, tested at VIL Max.

IAPU

-10

-130

µA

Input Capacitance 2

All input-only pins

All input/output (three-state) pins

Cin

—

NOTES:

Refer to the signals section for pins having weak internal pull-up devices.

This parameter is characterized before qualification rather than 100% tested.

Table 7. DC Electrical Specifications (continued)

Characteristic

Symbol

Min

Max

Unit

Board VDD

Ω

0.1 µF

PLL VDD Pin

10 µF

GND

MCF5373CAB180 bảng dữ liệu(PDF) 17 Page - Freescale Semiconductor, Inc

MCF5373CAB180 bảng dữ liệu(HTML) 17 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

bảng dữ liệu tải về

Link URL