IN100-Q1-R-RC1F datasheet(15/49 Pages) ETC

15 / 49 page

14 / 47

www.inplay-tech.com

N1EDOC-DS-IN100-EN-V1.3

3. Function Block Description

3.1. Overview of beacon packets and beacon data set creation

The device is designed to be configure-and-use, so that the users do not need to do any software

or application programing. Figure 4 shows the advertising packet format, number of packets that

are supported, and packet control settings. The user can employ the provided NanoBeacon Config

PC GUI tools to generate the configuration file to be programmed into the eFuse memory of the

device.

Figure 4：Advertising packet and advertising packet creation process overview

3.2. Advertising control and packet definition

There are two advertising modes: continuous and event driven. In continuous advertising mode,

advertising occurs every advertising interval upon power-on; In event-driven advertising mode,

advertising only occurs when triggered by specified external events. For example, event-driven

advertising can happen after some sensor ADC measurements are larger or smaller than a

predefined threshold.

The device supports three different data sets for advertising. The control of the advertising is

stored in eFuse memory or SRAM as shown in Figure 4.

3.3. eFuse memory (OTP)

IN100-Q1-R-RC1F bảng dữ liệu(PDF) 15 Page - List of Unclassifed Manufacturers