SPSB081 datasheet(22/135 Pages) STMICROELECTRONICS

22 / 135 page

Figure 13. Watchdog in debug mode

Note:

Whenever the device is operated without servicing the mandatory watchdog trigger events, a sequence

of 15 consecutive reset events is performed and the device is forced into Vbat_Stby mode with bit

FORCED_SLEEP_WD in SR1 set.

If the device is woken up after such a forced Vbat_Stby condition and the watchdog is still not serviced, the

device, after one long open watchdog window is reforced into the same Vbat_Stby mode until the next wake-up

event. In this case, an additional watchdog failure is generated, but the fail counter is not cleared, keeping the

maximum number of 15 failures. This sequence is repeated until a valid watchdog trigger event is performed by

writing TRIG=1.

3.6.1

Change watchdog timing

The watchdog trigger time can be configured by setting the WD_TIME (CR 2) bit. Writing to these bits is

only possible with the first SPI command after setting WD_CONFIG_EN = 1 (Config register (0x3F)). The

WD_CONFIG_EN bit is reset to 0 automatically with next SPI command.

When FAIL_SAFE is active, these SPI registers are not accessible. Therefore, the FAIL_SAFE status needs to be

cleared. In case of a WD_FAIL, the clear is performed by starting a long open window.

When a new configuration has been programmed, the watchdog behaves with the old configuration until the next

trig event.

The new value of WD_TIME is loaded in the watchdog module on the next trig event after the SPI configuration.

The following watchdog cycle uses the new programmed value.

3.7

Fail safe mode

3.7.1

Temporary failures

SPSB081 enters fail-safe mode in case of:

•

Watchdog failure

•

V1 failure (V1 < VRTx for t > tV1FS)

•

Thermal shutdown TSD2

The fail-safe functionality is also available in V1_Standby mode. During V1_Standby mode the fail-safe mode is

entered in the following cases:

•

Watchdog failure (if watchdog still running due to Iv1 > Icmp)

•

V1 failure (V1 < VRTx for t > tV1FS)

•

Thermal shutdown TSD2

In fail-safe mode, the device returns to a fail-safe state. The fail-safe condition is indicated to the system in the

global status byte. The conditions during the fail-safe mode are:

SPSB081

Fail safe mode

DS14048 - Rev 1

page 22/135

SPSB081 bảng dữ liệu(PDF) 22 Page - STMicroelectronics

SPSB081 bảng dữ liệu(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL