Features

•

LVDS single driver and single receiver

•

400 Mbps (200 MHz)

•

3 V to 3.6 V operating power supply

•

4.8 V absolute maximum ratings

•

Individual enable/disable function with high impedance

•

Cold spare on all pins

•

Fail-safe function

•

RML < 1% and CVCM <0.1% guaranteed outgassing

•

Nickel/palladium/gold-lead-finished (NiPdAu), whisker-free

•

Gold wires

•

50 krad (Si) total ionizing dose

•

SEL-free up to 62.5 MeV.cm²/mg

•

Mass: 80 mg

•

Compliant with ST-LEO-specification

Applications

•

Low earth orbit (LEO) satellites, high speed interface systems

Description

The LEOLVDSRD is a 3 V to 3.6 V power supply (4.8 V absolute maximum

ratings) low voltage differential signaling (LVDS) driver and receiver qualified for use

in aerospace environments. It operates over a controlled impedance of 100 ohm

transmission media that may be printed circuit board traces, back planes, or cables.

The circuit features an internal fail-safe function to ensure a known state in case of

an input short-circuit or floating input. All pins have cold spare buffers to ensure they

are in high impedance when VCC is tied to GND.

The LEOLVDSRD can operate over a large temperature range of -40 °C to +125 °C

and it is housed in plastic TSSOP-20, thin-shrink small outline package, 20 leads,

using gold-wires and nickel/palladium/golden-lead-finishing to prevent from whiskers.

The LEOLVDSRD is compliant with ST-LEO-specification, dedicated specification for

space-ready rad-hard plastic products. This AEC-Q100-based specification offers

a specific trade-off among footprint size savings, cost of ownership and quality

assurance together with radiation hardness and a large quantity capability.

Product status link

LEOLVDSRD

Rad-hard plastic LVDS driver-receiver

LEOLVDSRD

Datasheet

DS13673 - Rev 4 - June 2022

For further information contact your local STMicroelectronics sales office.

www.st.com