ADM2461E/ADM2463E

Data Sheet

Rev. 0 | Page 10 of 21

4

16

15

A

14

B

13

Z

12

Y

11

INVR

NOTES

1. NIC = NOT INTERNALLY CONNECTED.

7

NIC

10

9

ADM2463E

TOP VIEW

(Not to Scale)

RE

Figure 11. ADM2463E Full Duplex Pin Configuration

Table 12. ADM2463E Pin Function Descriptions

Pin No.

Mnemonic

Description

1

1.7 V to 5.5 V Flexible Primary Side Power Supply. Connect a 0.1 μF decoupling capacitor between Pin 1 and Pin 2

to decouple the two supplies. An additional 10 μF decoupling capacitor can be connected between Pin 1 and Pin

2 to improve noise immunity in noisy environments.

2, 8

Ground 1, Logic Side.

3

RxD

Receiver Output Data. When the INVR pin is logic low, this output is high when the differential receiver input voltage

(A – B) ≥ −30 mV and low when A – B ≤ –200 mV. When the INVR pin is logic high, this output is high when A – B ≤

30 mV and low when A – B ≥ 200 mV. When the RE pin is driven high, the receiver disables and this output is tristated.

4

RE

Receiver Enable Input. This pin is an active low input. Drive this input low to enable the receiver. Drive this input

high to disable the receiver.

5

DE

Driver Output Enable. A high level on this pin enables the driver differential outputs, Y and Z. A low level on this

pin places the outputs in a high impedance state.

6

TxD

Transmit Data Input. Data to be transmitted by the driver is applied to this input.

7

INVR

Receiver Cable Invert Input. This pin is an active high input. Drive this pin high to invert the A and B receiver inputs

to correct for reversed cable installation. This pin is pulled internally to ground through a high impedance. If the

9, 15

Isolated Ground 2 for the Integrated RS-485 Transceiver, Bus Side.

10

NIC

Not Internally Connected.

11

Y

Driver Noninverting Output.

12

Z

Driver Inverting Output.

13

B

Receiver Inverting Input.

14

A

Receiver Noninverting Input.

16

3.0 V to 5.5 V Isolated Side Power Supply. Connect a decoupling capacitor of 0.1 μF between Pin 16 and Pin 15 to

decouple the two supplies. An additional 10 μF decoupling capacitor can be connected between Pin 16 and Pin

15 to improve noise immunity in noisy environments.