ADGS1612BCPZ datasheet(21/29 Pages) AD

21 / 29 page

Data Sheet

ADGS1612

Rev. 0 | Page 21 of 29

TERMINOLOGY

IDD

IDD is the positive supply current.

ISS

ISS is the negative supply current.

VD, VS

VD and VS are the analog voltages on Terminal D and Terminal

S, respectively.

RON

RON is the ohmic resistance between Terminal D and Terminal

ΔRON

ΔRON is the difference between the RON of any two channels.

RFLAT (ON)

RFLAT (ON) is the difference between the maximum and minimum

values of on resistance, measured over the specified analog

signal range.

IS (Off)

IS (Off) is the source leakage current with the switch off.

ID (Off)

ID (Off) is the drain leakage current with the switch off.

ID (On), IS (On)

ID (On) and IS (On) are the channel leakage currents with the

switch on.

IDS

IDS is the drain to source current.

V1 is the voltage drop across the switch, Sx, to Dx.

VINL

VINL is the maximum input voltage for Logic 0.

VINH

VINH is the minimum input voltage for Logic 1.

IINL, IINH

IINL and IINH is the low and high input currents of the digital

inputs.

CD (Off)

CD (Off) is the off switch drain capacitance, which is measured

with reference to ground.

CS (Off)

CS (Off) is the off switch source capacitance, which is measured

with reference to ground.

CD (On), CS (On)

CD (On) and CS (On) are the on switch capacitances, measured

with reference to ground.

CIN

CIN is the digital input capacitance.

tON

tON is the delay between applying the digital control input and

the output switching on.

tOFF

tOFF is the delay between applying the digital control input and

the output switching off.

tD is the off time measured between the 80% point of both

switches when switching from one address state to another.

Off Isolation

Off isolation is a measure of unwanted signal coupling through

an off switch.

Charge Injection

Charge injection is a measure of the glitch impulse transferred

from the digital input to the analog output during switching.

Crosstalk

Crosstalk is a measure of unwanted signal that is coupled

through from one channel to another as a result of parasitic

capacitance.

Bandwidth

Bandwidth is the frequency at which the output is attenuated

by 3 dB.

On Response

On response is the frequency response of the on switch.

Insertion Loss

Insertion loss is the loss due to the on resistance of the switch.

Total Harmonic Distortion Plus Noise (THD + N)

THD + N is the ratio of the harmonic amplitude plus noise of

the signal to the fundamental.

AC Power Supply Rejection Ratio (AC PSRR)

AC PSRR is the ratio of the amplitude of signal on the output to

the amplitude of the modulation. AC PSRR is a measure of the

ability of the device to avoid coupling noise and spurious signals

that appear on the supply voltage pin to the output of the switch.

The dc voltage on the device is modulated by a sine wave of

0.62 V p-p.

ADGS1612BCPZ bảng dữ liệu(PDF) 21 Page - Analog Devices

ADGS1612BCPZ bảng dữ liệu(HTML) 21 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

bảng dữ liệu tải về

Link URL