XRT7250 datasheet(300/463 Pages) EXAR

300 / 463 page

áç

XRT7250

DS3/E3 FRAMER IC

REV. 1.1.1

281

5.2.6

Transmit Section Interrupt Processing

The Transmit Section of the XRT7250 can generate

an interrupt to the Microprocessor/Microcontroller for

the following reasons.

• Completion of Transmission of LAPD Message

5.2.6.1

Enabling Transmit Section Interrupts

The Interrupt Structure, within the XRT7250 contains

two hierarchical levels:

• Block Level

• Source Level

The Block Level

The Enable State of the Block Level for the Transmit

Section Interrupts dictates whether or not interrupts

(enabled) at the source level, are actually enabled.

The user can enable or disable these Transmit Sec-

tion interrupts, at the Block Level by writing the appro-

priate data into Bit 1 (Tx DS3/E3 Interrupt Enable)

within the Block Interrupt Enable register (Address =

0x04), as illustrated below.

FIGURE 125. WAVEFORM/TIMING RELATIONSHIP BETWEEN TXLINECLK, TXPOS AND TXNEG - TXPOS AND

TXNEG ARE CONFIGURED TO BE UPDATED ON THE RISING EDGE OF TXLINECLK

TxLineClk

TxPOS

TxNEG

t32

t30

t33

FIGURE 126. WAVEFORM/TIMING RELATIONSHIP BETWEEN TXLINECLK, TXPOS AND TXNEG - TXPOS AND

TXNEG ARE CONFIGURED TO BE UPDATED ON THE FALLING EDGE OF TXLINECLK

TxLineClk

TxPOS

TxNEG

t31

t32

t33

XRT7250 bảng dữ liệu(PDF) 300 Page - Exar Corporation

XRT7250 bảng dữ liệu(HTML) 300 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL