STM8S datasheet(62/467 Pages) STMICROELECTRONICS

tên linh kiện	STM8S

Giải thích chi tiết về linh kiện	STM8S Series and STM8AF Series 8-bit microcontrollers

PDF	467 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

62 / 467 page

Interrupt controller (ITC)

RM0016

62/467

DocID14587 Rev 14

or TLI interrupt occurs. The corresponding vector is then loaded in the PC register and bits

I1 and I0 of the CCR register are set to disable interrupts (level 3).

•

TRAP (non-maskable software interrupt)

This software interrupt source is serviced when the TRAP instruction is executed. It is

serviced accordingly to the flowchart shown in Figure 13.

A TRAP interrupt does not allow the processor to exit from Halt mode.

•

RESET

The RESET interrupt source has the highest STM8 software and hardware priorities.

This means that all the interrupts are disabled at the beginning of the reset routine.

They must be re-enabled by the RIM instruction (see Table 11: Dedicated interrupt

instruction set).

A RESET interrupt allows the processor to exit from Halt mode.

See RESET chapter for more details on RESET interrupt management.

•

TLI (top level hardware interrupt)

This hardware interrupt occurs when a specific edge is detected on the corresponding

TLI input. It is serviced accordingly to the flowchart shown in Figure 13.

Caution:

A TRAP instruction must not be used in a TLI service routine.

STM8S bảng dữ liệu(PDF) 62 Page - STMicroelectronics