2. Teach the first sensing condition.

Method

Action

Result

Via push button

Present the first sensing condition and click the push

button.

The amber LED is off. The red LED pulses to indicate

relative signal strength. The sensor registers the

output ON condition and is ready for the output OFF

condition.

Via remote line

Present the first sensing condition and single-pulse the

remote line.

3. Teach the second sensing condition and return to RUN mode.

Method

Action

Result

Via push

button

Present the second sensing condition

and click the push button.

If the teach is accepted the green LED is on (or flashes if the signal is

close to the switching threshold) and the amber LED is off until the

sensing condition changes; the sensor registers the output OFF

condition, positions the threshold, and returns to RUN mode.

If the teach is not accepted, the amber LED is on and the red LED pulses

to indicate the relative received signal strength. The sensor returns to its

wait state and is ready for the first sensing condition.

Via remote line Present the second sensing condition

and single-pulse the remote line.

NOTE: The sensor returns to RUN mode if the first TEACH condition is not registered within 90 seconds. TEACH mode may be

cancelled before either the first or second condition by holding the push button depressed for more than two seconds.

Enabling or Disabling the Push Button

In addition to its programming function, the remote line may be used to disable the push buttons for security. Disabling

the push buttons prevents undesired tampering with the sensor configuration settings.

1. Connect the sensor’s gray wire.

2. Four-pulse the remote line to enable or disable the push button.

The sensor toggles between enable and disable settings and returns to RUN mode.

MINI-BEAM SME312 Expert Series

P/N 55214 Rev. G

www.bannerengineering.com - Tel: +1-763-544-3164

5