DZM5168M

Revision 1.02

Page

of 17

Aug. 2014

11

22

ATSC

R/S the searching channel

0x0001~0xFFFE

0x0003

23

ATSH

Read the high 32-bit of IEEE 64-bit address

0x00000000~

0xFFFFFFFF

24

ATSL

Read the low 32-bit of IEEE 64-bit address

0x00000000~

0xFFFFFFFF

25

ATSM

R/S sleep mode, only for EndDevice

0: disable

1: enable

0

26

ATSP

The limitation time for Coordinator or Router to

keep data for EndDevice or the period for

EndDevice to obtain data from Coordinator or

Router.

0x0001~0xFFFF

0x12C

27

ATST

The working time of EndDevice after it is waken

up. The value (ms) must not exceed half of the

value set by ASTP command. Only effective for

EndDevice.

0x0001~0xFFFF

0x32

28

ATVR

Software version

0x00~0xFF

29

ATWR

Save the revised parameters to memory. The

module will work on new parameters after being

reset.

30

ATJN

Forbid joining network. Only effective for

Coordinator or Router.

0: forbid

1: allow

1

Table 16: DZM5168M AT Command Set

1.

ATAI

This command is used to inquiry the network status of EndDevice If the returned value is 0,

it means the EndDevice is in the network. In other words it has the father node. The

searching time for EndDevice to join the network is from several hundreds of milliseconds to

several seconds so it might need to use this command for a few times in order to get the

status. Furthermore the father node might be different for each time of the EndDevice to join

the network.

2.

ATAP

It is used to read or set the working mode of modules. If the parameter following the

command is 0 (ATAP 0), the module will enter into transparent mode after quitting

configuration mode. Similarly the module will enter into API mode if the parameter is 1.

3.

ATBD

This command is used to read or set the UART data rate. Lower data rate is not

recommended in case the buffer is overflowed. This command is only effective in

configuration mode so it is not applicable in API mode. The command comes into effective

after the module is reset.