GD25B32CSIG datasheet(12/56 Pages) GIGADEVICE

12 / 56 page

3.3V Uniform Sector

Dual and Quad Serial Flash

GD25B32C

LB3, LB2, LB1 bits.

The LB3, LB2, LB1 bits are non-volatile One Time Program (OTP) bits in Status Register (S13-S11) that provide the

write protect control and status to the Security Registers. The default state of LB3-LB1 are 0, the security registers are

unlocked. The LB3-LB1 bits can be set to 1 individually using the Write Register instruction. The LB3-LB1 bits are One

Time Programmable, once its set to 1, the Security Registers will become read-only permanently.

CMP bit

The CMP bit is a non-volatile Read/Write bit in the Status Register (S14). It is used in conjunction the BP4-BP0 bits to

provide more flexibility for the array protection. Please see the Status registers Memory Protection table for details. The

default setting is CMP=0.

SUS1, SUS2 bit

The SUS1 and SUS2 bits are read only bits in the status register (S15 and S10) that are set to 1 after executing an

Program/Erase Suspend (75H) command (The Erase Suspend will set the SUS1 to 1,and the Program Suspend will set

the SUS2 to 1). The SUS1 and SUS2 bits are cleared to 0 by Program/Erase Resume (7AH) command as well as a

power-down, power-up cycle.

HPF bit

The High Performance Flag (HPF) bit indicates the status of High Performance Mode (HPM). When HPF bit sets to 1,

it means the device is in High Performance Mode, when HPF bit sets 0 (default), it means the device is not in High

Performance Mode.

DRV1, DRV0 bits

The DRV1&DRV0 bits are used to determine the output driver strength for the Read operations.

DRV1,DRV0

Driver Strength

100%

75% (default)

50%

25%

GD25B32CSIG bảng dữ liệu(PDF) 12 Page - GigaDevice Semiconductor (Beijing) Inc.