AD9684 datasheet(33/65 Pages) AD

33 / 65 page

AD9684

Data Sheet

NCO

MIXER

(OPTIONAL)

DDC 3

SYNC±

REAL/I

REAL/Q

REAL/I

CONVERTER 6

Q CONVERTER 7

NCO

MIXER

(OPTIONAL)

DDC 0

SYNC±

REAL/I

REAL/Q

REAL/I

CONVERTER 0

Q CONVERTER 1

NCO

MIXER

(OPTIONAL)

DDC 1

SYNC±

REAL/I

REAL/Q

REAL/I

CONVERTER 2

Q CONVERTER 3

NCO

MIXER

(OPTIONAL)

DDC 2

SYNC±

REAL/I

REAL/Q

REAL/I

CONVERTER 4

Q CONVERTER 5

ADC

SAMPLING

REAL/I

ADC

SAMPLING

REAL/I

SYNCHRONIZATION

CONTROL CIRCUITS

SYNC±

Figure 58. DDC Detailed Block Diagram

Figure 59 shows an example usage of one of the four DDC

blocks with a real input signal and four half-band filters (HB4 +

HB3 + HB2 + HB1). It shows both complex (decimate by 16)

and real (decimate by 8) output options.

When DDCs have different decimation ratios, the chip decimation

ratio (Register 0x201) must be set to the lowest decimation ratio

for all the DDC blocks. In this scenario, samples of higher decima-

tion ratio DDCs are repeated to match the chip decimation ratio

sample rate. Whenever the NCO frequency is set or changed,

the DDC soft reset must be issued. If the DDC soft reset is not

issued, the output may potentially show amplitude variations.

Table 10 through Table 15 show the DDC samples when the

chip decimation ratio is set to 1, 2, 4, 8, or 16, respectively.

When DDCs have different decimation ratios, the chip

decimation ratio must be set to the lowest decimation ratio of

all the DDC channels. In this scenario, samples of higher

decimation ratio DDCs are repeated to match the chip

decimation ratio sample rate.

Rev. 0 | Page 32 of 64

AD9684 bảng dữ liệu(PDF) 33 Page - Analog Devices

AD9684 bảng dữ liệu(HTML) 33 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

bảng dữ liệu tải về

Link URL