STM8L151F3 datasheet(54/122 Pages) STMICROELECTRONICS

54 / 122 page

Electrical parameters

STM8L151x2, STM8L151x3

54/122

DocID018780 Rev 9

Electrical parameters

9.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

9.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA= 25 °C and TA = TA max (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

is indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean±3

Σ).

9.1.2

Typical values

Unless otherwise specified, typical data is based on TA = 25 °C, VDD = 3 V. It is given only as

design guidelines and is not tested.

Typical ADC1 accuracy values are determined by characterization of a batch of samples

from a standard diffusion lot over the full temperature range, where 95% of the devices have

an error less than or equal to the value indicated (mean±2

Σ).

9.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

9.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 9.

Figure 9. Pin loading conditions

STM8L151F3 bảng dữ liệu(PDF) 54 Page - STMicroelectronics