STM8L101X3 datasheet(37/88 Pages) STMICROELECTRONICS

37 / 88 page

DocID15275 Rev 16

37/88

STM8L101x1 STM8L101x2 STM8L101x3

Electrical parameters

9.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

9.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA= 25 °C and TA = TA max (given by

the selected temperature range).

Note:

The values given at 85 °C <TA ≤ 125 °C are only valid for suffix 3 versions.

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean±3

Σ).

9.1.2

Typical values

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 3 V. They are given

only as design guidelines and are not tested.

9.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

9.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 9.

Figure 9. Pin loading conditions

STM8L101x3 bảng dữ liệu(PDF) 37 Page - STMicroelectronics