TFP201, TFP201A

TI PanelBus DIGITAL RECEIVER

SLDS116A - MARCH 2000 – REVISED JUNE 2000

13

POST OFFICE BOX 655303

TFP201A incorporates HSYNC jitter immunity (continued)

This HSYNC regeneration circuit is transparent to the monitor and need not be removed even if the transmitted

HSYNC is stable. For example, the PanelBus line of DVI 1.0 compliant transmitters, such as the TFP6422 and

TFP420, do not have the HSYNC jitter problem. The TFP201A will operate correctly with either compliant or

noncompliant transmitters. In contrast, the TFP201 is ideal for customers who have control over the transmit

portion of the design such as bundled system manufacturers and for internal monitor use (the DVI connection

between monitor and panel modules).

HSYNC Shift by

± 1 Clock

ODCK

HSYNC IN

DE

HSYNC OUT

Figure 16. HSYNC Regeneration Timing Diagram

TFP201/201A modes of operation

The TFP201/201A provides systems design flexibility and value by providing the system designer with

configurable options or modes of operation to support varying system architectures. The following table outlines

the various panel modes that can be supported along with appropriate external control pin settings.

PANEL

PIXEL RATE

ODCK LATCH

EDGE

ODCK

DFO

PIXS

OCK_INV

TFT or 16-bit DSTN

1 pix/clock

Falling

Free run

0

0

0

TFT or 16-bit DSTN

1 pix/clock

Rising

Free run

0

0

1

TFT

2 pix/clock

Falling

Free run

0

1

0

TFT

2 pix/clock

Rising

Free run

0

1

1

24-bit DSTN

1 pix/clock

Falling

Gated low

1

0

0

NONE

1 pix/clock

Rising

Gated low

1

0

1

24-bit DSTN

2 pix/clock

Falling

Gated low

1

1

0

24-bit DSTN

2 pix/clock

Rising

Gated low

1

1

1

TFP201/201A output driver configurations

The TFP201/201A provides flexibility by offering various output driver features that can be used to optimize

power consumption, ground-bounce and power-supply noise. The following sections outline the output driver

features and their effects.

Output driver power down (PDO = low), Pulling PDO low will place all the output drivers, except CTL1 and

SCDT, into a high-impedance state. The SCDT output which indicates link-disabled or link-inactive can be tied

directly to the PDO input to disable the output drivers when the link is inactive or when the cable is disconnected.

An internal pullup on the PDO pin will default the TFP201/201A to the normal nonpower down output drive mode

if left unconnected.