TMS320VC5501 datasheet(129/193 Pages) TI

129 / 193 page

Functional Overview

129

December 2002 − Revised November 2004

SPRS206H

3.17 Notice Concerning TCK

Under certain conditions, the emulation hardware may corrupt the emulation control state machine or may

cause it to lose synchronization with the emulator software. When emulation commands fail as a result of the

problem, Code Composer Studio

 Integrated Development Environment (IDE) may be unable to start or it

may report errors when interacting with the TMS320C55x

 DSP (for example, when halting the CPU,

reaching a breakpoint, etc.).

This phenomenon is observed when an erroneous clock edge is generated from the TCK signal inside the

C55x

 DSP. This can be caused by several factors, acting independently or cumulatively:

•

TCK transition times (as measured between 2.4 V and 0.8 V) in excess of 3 ns.

•

Operating the C55x DSP in a socket, which can aggravate noise or glitches on the TCK input.

•

Poor signal integrity on the TCK line from reflections or other layout issues.

A TCK edge that can cause this problem might look similar to the one shown in Figure 3−53. A TCK edge that

does not cause the problem looks similar to the one shown in Figure 3−54. The key difference between the

two figures is that Figure 3−54 has a clean and sharp transition whereas Figure 3−53 has a “knee” in the

transition zone. Problematic TCK signals may not have a knee that is as pronounced as the one in

Figure 3−53. Due to the TCK signal amplification inside the chip, any perturbation of the signal can create

erroneous clock edges.

As a result of the faster edge transition, there is increased ringing in Figure 3−54. As long as the ringing does

not cross logic input thresholds (0.8 V for falling edges, and 2.4 V for rising edges), this ringing is acceptable.

When examining a TCK signal for this issue, either in board simulation or on an actual board, it is very important

to probe the TCK line as close to the DSP input pin as possible. In simulation, it should not be difficult to probe

right at the DSP input. For most physical boards, this means using the via for the TCK pad on the back side

of the board. Similarly, ground for the probe should come from one of the nearby ground pad vias to minimize

EMI noise picked up by the probe.

Code Composer Studio, TMS320C55x, and C55x are trademarks of Texas Instruments.

TMS320VC5501 bảng dữ liệu(PDF) 129 Page - Texas Instruments