| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
WM8608 bảng dữ liệu(PDF) 38 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8608 bảng dữ liệu(HTML) 38 Page - Wolfson Microelectronics plc |
|
38 / 54 page ![]() WM8608 Product Preview w PP Rev 1.5 March 2004 38 ATTACK AND DECAY TIMES The attack time-constant ATK controls how fast the gain is reduced when the signal goes above the threshold. It is defined as the time taken for the gain to reduce by 6dB. Normally a short attack time- constant is used to prevent the signal clipping when a high-amplitude transient occurs. The decay time-constant DCY controls how fast the gain is increased when the signal begins to fall again. It is defined as the time taken for the gain to increase by 6dB. Normally, the decay time- constant is much longer than the attack time-constant, to prevent the input signal from entering repeated limiting cycles. The frequency-dependent decay feature automatically detects the input frequency and sets the decay time to decay slower for low frequency signals. This reduces low-frequency signal distortion by preserving the waveform of each input cycle, whilst allowing the compressor to respond quickly to high frequency transients. This feature is enabled via the FDEP control bit. ZERO-CROSS The Dynamic Peak Compressor has a zero cross detector to prevent gain changes introducing clicks in the signal. The ZC is controlled by the same register R25 used in the volume control. 0dB Output Level (dB) Peak Input Level [dB] THRESH [dB] 0 -6 -12 +6 +12 -18 -24 -30 -36 -12 -18 -24 -30 -36 0dB -6dB -12dB +6dB +12dB typical Volume Control Setting Figure 22 Dynamic Peak Compressor Characteristics REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION 0 PLENF 1 Front Channel Compressor Enable 0 = disable 1 = enable 1 PLENS 1 Surround Channel Compressor Enable 0 = disable 1 = enable R21 (15h) Front, Surround, Front Centre and Rear Centre Channel Dynamic Peak Compressor 2 PLENC 1 Front Centre and Rear Centre Channel Compressor Enable 0 = disable 1 = enable Table 36 Front, Surround, Front Centre and Rear Centre Channel Dynamic Peak Compressor (1) |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |