| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
P89682K bảng dữ liệu(PDF) 39 Page - Aplus Intergrated Circuits |
|
|
|||||||||||||||||||||||||||||
P89682K bảng dữ liệu(HTML) 39 Page - Aplus Intergrated Circuits |
|
39 / 44 page ![]() Integrated Circuits Inc. aP89682K/341K/170K/085K Ver 2.5.1 39 May 24 2016 I2C Mode Fig. 37 Note: 1. If voltage is higher than 4.0V, C (0.1uF(typ)) is necessary for endure high voltage and protect it from noise which may affect its performance. Distance between caps and ICs should be minimized to reduce spreading inductance. The wiring length between the IC and caps may be less than 150mil. 2. Rp is used to filter noise from power line. A. Rp is unnecessary in DAC mode or VDD less than 3.6v. The value of Rp is 0 ohm in DAC mode. B. If voltage is higher than 3.6V and chip is configured as PWM mode, Rp is necessary for system stability. The value of Rp is 56 ohm in PWM mode. The minimum operating voltage would be lifted from 2.0v to 2.2v, when Rp is added. C. If Rp is added and there are LED drove by OUT[1:3] pin, please configure the OUT pin as active low to drive LED. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |