SST49LF016C datasheet(8/43 Pages) MICROCHIP

8 / 43 page

DS20005029B

02/16

16 Mbit LPC Serial Flash

SST49LF016C

EOL Data Sheet

Clock

The LCLK pin accepts a clock input from the host controller.

Input/Output Communications

The LAD[3:0] pins are used to serially communicate cycle information such as cycle type, cycle direc-

tion, ID selection, address, data, and sync fields.

Input Communication Frame

The LFRAME# pin is used to indicate start of a LPC bus cycle. The pin is also used to abort an LPC

bus cycle in progress.

Reset

A VIL on INIT# or RST# pin initiates a device reset. INIT# and RST# pins have the same function inter-

nally. It is required to drive INIT# or RST# pins low during a system reset to ensure proper CPU initial-

ization. During a Read operation, driving INIT# or RST# pins low deselects the device and places the

output drivers, LAD[3:0], in a high impedance state. The reset signal must be held low for a minimum

of time TRSTP. A reset latency occurs if a reset procedure is performed during a Program or Erase oper-

ation. See Table 27, Reset Timing Parameters, for more information. A device reset during an active

Program or Erase operation will abort the operation and memory contents may become invalid due to

data being altered or corrupted from an incomplete Erase or Program operation.

Identification Inputs

These pins are part of a mechanism that allows multiple devices to be attached to the same bus. The

strapping of these pins is used to identify the component. The boot device must have ID[3:0] = 0; all

subsequent devices should use sequential count-up strapping. These pins are internally pulled-down

with a resistor between 20-100 K.

General Purpose Inputs

The General Purpose Inputs (GPI[4:0]) can be used as digital inputs for the CPU to read. The GPI reg-

ister holds the values on these pins. The data on the GPI pins must be stable before the start of a GPI

high, VIH but not left unconnected (float).

SST49LF016C bảng dữ liệu(PDF) 8 Page - Microchip Technology