STM32F334X4 datasheet(28/115 Pages) STMICROELECTRONICS

28 / 115 page

Functional overview

STM32F334x4 STM32F334x6 STM32F334x8

28/115

DocID025409 Rev 5

3.16.4

Controller area network (CAN)

The CAN is compliant with specifications 2.0A and B (active) with a bit rate up to 1 Mbit/s. It

can receive and transmit standard frames with 11-bit identifiers as well as extended frames

with 29-bit identifiers. It has three transmit mailboxes, two receive FIFOs with 3 stages and

14 scalable filter banks.

3.17

Infrared transmitter

The STM32F334x4/6/8 devices provide an infrared transmitter solution. The solution is

based on internal connections between TIM16 and TIM17 as shown in the figure below.

TIM17 is used to provide the carrier frequency and TIM16 provides the main signal to be

sent. The infrared output signal is available on PB9 or PA13.

To generate the infrared remote control signals, TIM16 channel 1 and TIM17 channel 1 must

be properly configured to generate correct waveforms. All standard IR pulse modulation

modes can be obtained by programming the two timers output compare channels.

Figure 3. Infrared transmitter

3.18

Touch sensing controller (TSC)

The STM32F334x4/6/8 devices provide a simple solution for adding capacitive sensing

functionality to any application. These devices offer up to 18 capacitive sensing channels

distributed over 6 analog I/Os group.

Capacitive sensing technology is able to detect the presence of a finger near an electrode

which is protected from direct touch by a dielectric (glass, plastic, ...). The capacitive

variation introduced by the finger (or any conductive object) is measured using a proven

implementation based on a surface charge transfer acquisition principle. It consists of

NSS pulse mode

TI mode

1. X = supported.

Table 9. STM32F334x4/6/8 SPI implementation (continued)

SPI features(1)

SPI1

STM32F334X4 bảng dữ liệu(PDF) 28 Page - STMicroelectronics