LP064V1 LIQUID CRYSTAL DISPLAY

SPECIFICATIONS

TITLE: LP064V1 REV. 1 PAGE 18 OF 18

DATA DISPLAY AG

Industriestrasse 1

D-82110 Germering

DEZ 1999

http://www.datadisplay.de

Tel.: +49-89-894450-0

Fax: +49-89-894450-90

• When the module with protection film attached is stored for long time, sometimes

there remains a very small amount of glue still on the polarizer after the

protection film is pealed off. Please refrain from storing the module at the high

temperature and high humidity for glue is apt to remain in these condition.

• The glue may be taken for the modules failure, but you can remove the giue

easily. When the glue remains on the polarizer surface or its vestige is

recognized, please wipe them off with absorbent cotton waste or other soft

material like chamois soaked with Normal-hexane.

13.7 SAFETY

• If module is broken, be careful to handle not to injure. (TFT/LCD and lamp are

made of glass). Please wash hands sufficiently when you touch the liquid crystal

coming out from broken LCDs.

• As it is possible for PCB or other electronic parts of module to small to smoke

and to take fire because of the short circuit. Please design the circuit of your

instrument not to flow the electric current to TFT/LCD module more than 500mA.

(by apply the fuse for example)

• As Back-light unit has high voltage circuit internal, do not open the case and do

not insert foreign materials in the case.