CS89712 datasheet(18/170 Pages) CIRRUS

tên linh kiện	CS89712

Giải thích chi tiết về linh kiện	HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH 10BASE-T ETHERNET CONTROLLER

PDF	170 Pages

Scroll/Zoom	100%

nhà sản xuất	CIRRUS [Cirrus Logic]

Trang chủ	http://www.cirrus.com

Logo

18 / 170 page

CS89712

DS502PP2

serted by the interrupt controller. (A descrip-

tion for each bit in this register can be found in

Section 3.6.1.

3) If interrupts are enabled the processor will

jump to the appropriate address.

4) Interrupt dispatch software reads the interrupt

status register to establish the source(s) of the

interrupt and calls the appropriate interrupt ser-

vice routine(s).

5) Software in the interrupt service routine will

clear the interrupt source by some action spe-

cific to the device requesting the interrupt (i.e.,

reading the UART RX register).

The interrupt service routine may then re-enable in-

terrupts, and any other pending interrupts will be

serviced in a similar way. Alternately, it may return

to the interrupt dispatch code, which can check for

any more pending interrupts and dispatch them ac-

cordingly. The “End of Interrupt” type interrupts

are latched. All other interrupt sources (i.e., exter-

nal interrupt source) must be held active until its re-

spective service routine starts executing. See

Section 3.13, “End Of Interrupt Locations” for

more details.

Table 7, Table 8, and Table 9 show the names and

allocation of interrupts in the CS89712.

CS89712 bảng dữ liệu(PDF) 18 Page - Cirrus Logic