EMC1183 datasheet(36/48 Pages) MICROCHIP

36 / 48 page

Triple Channel 1°C Temperature Sensor with Beta Compensation and 1.8V SMBus Communications

Datasheet

Revision 1.0 (07-11-13)

SMSC EMC1183

DATASHEET

use this value to set the respective counters. The bits are decoded as shown in Table 6.14. The default

setting is 1 consecutive out of limit conversion.

6.13

Beta Configuration Registers 25h and 26h

This register is used to set the Beta Compensation factor that is used for s.

Bit 3 - ENABLE1X - Enables the Beta Compensation factor auto-detection function External Diode

2External Diode 1.

beta compensation cannot be enabled for External Diode 2 or 3.



‘0’ - The Beta Compensation Factor auto-detection circuitry is disabled.



‘1’ (default) - The Beta Compensation factor auto-detection circuitry is enabled. At the beginning of

every conversion, the optimal Beta Compensation factor setting will be determined and applied.

The BETA1X[2:0] bits will be automatically updated to indicate the current setting. This is the

default for EMC1183; and cannot be enabled for External Diode 2 or 3.

Bit 2-0 - BETAX[2:0] - These bits always reflect the current beta configuration settings. If auto-detection

circuitry is enabled, these bits will be updated automatically and writing to these bits will have no effect.

If the auto-detection circuitry is disabled, these bits will determine the beta configuration setting that is

used for the respective channels. Care should be taken when setting the BETAX[2:0] bits when the

auto-detection circuitry is disabled. If the Beta Compensation factor is set at a beta value that is higher

than the transistor beta, the circuit may introduce measurement errors. When measuring a discrete

thermal diode (such as 2N3904) or a CPU diode that functions like a discrete thermal diode (such as

an AMD processor diode), the BETAX[2:0] bits should be set to ‘111b’.

Table 6.14 Consecutive Alert / Therm Settings

NUMBER OF CONSECUTIVE OUT OF LIMIT

MEASUREMENTS

(default for CALRT[2:0])

(default for CTHRM[2:0])

Table 6.15 Beta Configuration Registers

ADDR.

R/W

DEFAULT

25h

R/W

External

Diode 1 Beta

Configuration

ENABLE1

BETA1[2:0]

08h

26h

External

Diode 2 Beta

Configuration

ENABLE2

BETA2[2:0]

08h

EMC1183 bảng dữ liệu(PDF) 36 Page - Microchip Technology

EMC1183 bảng dữ liệu(HTML) 36 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

bảng dữ liệu tải về

Link URL