CC2650MODAMOHT datasheet(26/40 Pages) TI1

26 / 40 page

CC2650MODA

SWRS187A – AUGUST 2016 – REVISED AUGUST 2016

www.ti.com

Submit Documentation Feedback

Product Folder Links: CC2650MODA

Detailed Description

(1)

Up to 13 pins can be connected to the Sensor Controller. Up to eight

of these pins can be connected to analog modules

Table 6-1. GPIOs Connected to the Sensor Controller(1)

ANALOG CAPABLE

16.9 × 11 MOH DIO NUMBER

6.6

Memory

The flash memory provides nonvolatile storage for code and data. The flash memory is in-system

programmable.

The SRAM (static RAM) can be used for both storage of data and execution of code and is split into two

4-KB blocks and two 6-KB blocks. Retention of the RAM contents in standby mode can be enabled or

disabled individually for each block to minimize power consumption. In addition, if flash cache is disabled,

the 8KB of cache can be used as a general-purpose RAM.

The ROM provides preprogrammed embedded TI-RTOS kernel, Driverlib and lower layer protocol stack

software (802.15.4 MAC and Bluetooth low energy Controller). The ROM also contains a bootloader that

can be used to reprogram the device using SPI or UART.

6.7

Debug

The on-chip debug support is done through a dedicated cJTAG (IEEE 1149.7) or JTAG (IEEE 1149.1)

interface.

CC2650MODAMOHT bảng dữ liệu(PDF) 26 Page - Texas Instruments