–100

–80

–60

–40

–20

0

20

40

60

–1

–0.5 0.0

0.5

1.0

1.5

2.0

2.5

3.0

3.5

4.0

TA = 25°C, VCC = 3 V,

VIH = 3 V, VIL = 0 V,

All Outputs Switching

VOH – V

VOL – V

–20

0

20

40

60

80

100

–0.2

0.0

0.2

0.4

0.6

0.8

1.0

1.2

1.4

1.6

TA = 25°C, VCC = 3 V,

VIH = 3 V, VIL = 0 V,

All Outputs Switching

SN74LVC125A

www.ti.com

SCAS290Q – JANUARY 1993 – REVISED JANUARY 2015

Typical Application (continued)

–

–

Series resistors on the output may be used if the user desires to slow the output edge signal or limit the

output current.

10.2.3 Application Curves

11 Power Supply Recommendations

The power supply can be any voltage between the MIN and MAX supply voltage rating located in the

Recommended Operating Conditions table.

supply, a 0.1

capacitors are recommended for each power terminal. It is ok to parallel multiple bypass capacitors to reject

different frequencies of noise. Multiple bypass capacitors may be paralleled to reject different frequencies of

noise. The bypass capacitor should be installed as close to the power terminal as possible for the best results.

12 Layout

12.1 Layout Guidelines

When using multiple bit logic devices, inputs should not float. In many cases, functions or parts of functions of

digital logic devices are unused. Some examples are when only two inputs of a triple-input AND gate are used,

or when only 3 of the 4-buffer gates are used. Such input pins should not be left unconnected because the

undefined voltages at the outside connections result in undefined operational states.

Specified in Figure 7 are rules that must be observed under all circumstances. All unused inputs of digital logic

devices must be connected to a high or low bias to prevent them from floating. The logic level that should be

applied to any particular unused input depends on the function of the device. Generally they will be tied to GND

Copyright © 1993–2015, Texas Instruments Incorporated

Submit Documentation Feedback

11

Product Folder Links: SN74LVC125A