TUSB5052PZ datasheet(57/82 Pages) TI

57 / 82 page

7−9

7.1.10 XON[2:1]: Xon Registers (2 Registers)

These registers contain a value that is compared to the received data stream. Detection of a match interrupts the MCU

(only if the interrupt enable bit is set). This value is also used for Xon transmission.

R/W

BIT

NAME

RESET

FUNCTION

7−0

D[7:0]

0x00

Xon value to be compared to the incoming data stream.

7.1.11 XOFF[2:1]: Xoff Registers (2 Registers)

These registers contain a value that is compared to the received data stream. Detection of a match halts the DMA

transfer, and interrupts the MCU (only if the interrupt enable bit is set). This value is also used for Xoff transmission.

R/W

BIT

NAME

RESET

FUNCTION

7−0

D[7:0]

0x00

Xon value to be compared to the incoming data stream.

7.1.12 MASK[2:1]: UART Interrupt-Mask Registers (2 Registers)

These registers control the UART interrupt sources. The corresponding DMA must be disabled before changing

RSV

TRIE

SIE

MIE

R/O

R/W

BIT

NAME

RESET

FUNCTION

MIE

This bit controls the UART-modem interrupt.

MIE = 0

Modem interrupt is disabled.

MIE = 1

Modem interrupt is enabled.

SIE

This bit controls the UART-status interrupt.

SIE = 0

Status interrupt is disabled.

SIE = 1

Status interrupt is enabled.

TRIE

This bit controls the UART-TxE/RxF interrupts.

TRIE = 0 TxE/RxF interrupts are disabled.

TRIE = 1 TxE/RxF interrupts are enabled.

7−3

RSV

Reserved = 0

7.2

UART Data Transfer

Figure 7−2 illustrates the data transfer between the UARTs and the host using the DMA controller and the USB buffer

manager (UBM). A buffer of 512 bytes is reserved for buffering all UART channels (2 transmit and 2 receive buffers).

Each UART channel has 64-bytes of double-buffer space (X- and Y-buffer). When the DMA writes to the X-buffer,

the UBM reads from the Y-buffer. Similarly, when the DMA reads from the X-buffer, the UBM writes to the Y-buffer.

The DMA channel is configured to operate in the continuous mode (by setting DMACDR[CNT] = 1). Once the MCU

enables the DMA, data transfer toggles between the UMB and the DMA without MCU intervention. See section 6.2

for DMA transfer-termination conditions.

TUSB5052PZ bảng dữ liệu(PDF) 57 Page - Texas Instruments

TUSB5052PZ bảng dữ liệu(HTML) 57 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

bảng dữ liệu tải về

Link URL