DAC5686IPZP datasheet(32/53 Pages) TI1

32 / 53 page

DA[15:0]

ts(DATA)

th(DATA)

TXENABLE

ts(TXENABLE)

CLK1 or

PLLLOCK

T0041-01

DA[15:0]

ts(DATA)

th(DATA)

QFLAG

CLK1 or

PLLLOCK

T0001-01

Clock Synchronization Using the PHSTR Pin in External Clock Mode

DAC5686

SLWS147F – APRIL 2003 – REVISED JUNE 2009 ............................................................................................................................................................ www.ti.com

Figure 35. Interleave Bus Mode Timing Diagram Using TxENABLE

Interleaved user data on data bus DA is alternately multiplexed to internal data channels A and B. Data channels

A and B can be synchronized using either the QFLAG pin or the TxENABLE pin. When qflag in register

config_usb is 0, transitions on TxENABLE identify the interleaved data sequence. The first data after the rising

edge of TxENABLE is latched with the rising edge of CLK as channel-A data. Data is then alternately distributed

to B and A channels with successive rising edges of CLK. When qflag is 1, the QFLAG pin is used as an input

by the user to identify the interleaved data sequence. QFLAG high identifies data as channel B (see Figure 36).

Figure 36. Interleave Bus Mode Timing Diagram Using QFLAG

When using interleaved input mode with the PLL enabled, the input clock CLK1 is at 2× the frequency of the

input to FIR1. The divider that generates the clock for the FIR1 input cannot be synchronized between multiple

DAC5686s, which can result in a one-CLK1-period output time difference between devices that have

synchronized input data. Dual-clock mode is recommended in applications where multiple DAC5686s must be

synchronized in interleaved input mode.

The dual-clock mode is selected by setting dualclk high in the config_usb register. In this mode, the DAC5686

uses both clock inputs; CLK1/CLK1C is the input data clock, and CLK2/CLK2C is the external clock. The edges

of the two input clocks must be phase-aligned within 500 ps to function properly.

In external clock mode, the DAC5686 is clocked at the DAC output sample frequency (CLK2 and CLK2C). For an

interpolation rate N, there are N possible phases for the DAC input clock on the PLLLOCK pin (see Figure 37 for

N = 4).

Submit Documentation Feedback

Product Folder Link(s): DAC5686

DAC5686IPZP bảng dữ liệu(PDF) 32 Page - Texas Instruments

DAC5686IPZP bảng dữ liệu(HTML) 32 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

bảng dữ liệu tải về

Link URL