AT45CS1282 datasheet(7/33 Pages) ATMEL

7 / 33 page

AT45CS1282 [Preliminary]

3447A–DFLSH–2/04

The six most-significant bits of the status register will contain device information, while

the remaining two least-significant bits are reserved for future use and will have unde-

fined values. After the one byte of the status register has been clocked out, the

sequence will repeat itself (as long as CS remains low and SCK/CLK is being toggled).

The data in the status register is constantly updated, so each repeating sequence will

output new data.

Ready/busy status is indicated using bit 7 of the status register. If bit 7 is a 1, then the

device is not busy and is ready to accept the next command. If bit 7 is a 0, then the

device is in a busy state. Since the data in the status register is constantly updated, the

user must toggle SCK/CLK pin to check the ready/busy status. There are four opera-

tions that can cause the device to be in a busy state: Main Memory Page to Buffer

Transfer, Main Memory Page to Buffer Compare, Buffer to Main Memory Page Program

and Sector Erase.

The result of the most recent Main Memory Page to Buffer Compare operation is indi-

cated using bit 6 of the status register. If bit 6 is a 0, then the data in the main memory

page matches the data in the buffer. If bit 6 is a 1, then at least one bit of the data in the

main memory page does not match the data in the buffer.

The device density is indicated using bits 5, 4, 3, and 2 of the status register. For the

AT45CS1282, the four bits are 0, 1, 0, 0. The decimal value of these four binary bits

does not equate to the device density; the four bits represent a combinational code

relating to differing densities of DataFlash devices. The device density is not the same

as the density code indicated in the JEDEC device ID information. The device density is

provided only for backward compatibility.

Status Register Format

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

RDY/BUSY

COMP

010

AT45CS1282 bảng dữ liệu(PDF) 7 Page - ATMEL Corporation