MB9B520M datasheet(48/113 Pages) SPANSION

48 / 113 page

D a t a S h e e t

March 18, 2015, MB9B520M_DS706-00048-3v0-E

CONFIDENTIAL

 Using an external clock

When using an external clock as an input of the main clock, set X0/X1 to the external clock input, and input

the clock to X0. X1(PE3) can be used as a general-purpose I/O port.

Similarly, when using an external clock as an input of the sub clock, set X0A/X1A to the external clock

input, and input the clock to X0A. X1A (P47) can be used as a general-purpose I/O port.

 Handling when using Multi-function serial pin as I2C pin

If it is using the multi-function serial pin as I

2C pins, P-ch transistor of digital output is always disabled.

However, I

2C pins need to keep the electrical characteristic like other pins and not to connect to the external

2C bus system with power OFF.

 C Pin

This series contains the regulator. Be sure to connect a smoothing capacitor (CS) for the regulator between

the C pin and the GND pin. Please use a ceramic capacitor or a capacitor of equivalent frequency

characteristics as a smoothing capacitor.

However, some laminated ceramic capacitors have the characteristics of capacitance variation due to

thermal fluctuation (F characteristics and Y5V characteristics). Please select the capacitor that meets the

specifications in the operating conditions to use by evaluating the temperature characteristics of a capacitor.

A smoothing capacitor of about 4.7μF would be recommended for this series.

 Mode pins (MD0)

Connect the MD pin (MD0) directly to VCC or VSS pins. Design the printed circuit board such that the

pull-up/down resistance stays low, as well as the distance between the mode pins and VCC pins or VSS pins

is as short as possible and the connection impedance is low, when the pins are pulled-up/down such as for

switching the pin level and rewriting the Flash memory data. It is because of preventing the device

erroneously switching to test mode due to noise.

• Example of Using an External Clock

Device

X0(X0A)

X1(PE3),

X1A (P47)

Can be used as

general-purpose

I/O ports.

Device

VSS

GND

Set as

External clock

input

MB9B520M bảng dữ liệu(PDF) 48 Page - SPANSION

MB9B520M bảng dữ liệu(HTML) 48 Page - SPANSION

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL