SRTAG2K-D datasheet(23/51 Pages) STMICROELECTRONICS

23 / 51 page

DocID025446 Rev 3

23/51

SRTAG2K-D

RF command sets

Note:

After receiving the deselect command, the session is released and SRTAG2K-D enters the

Standby power mode.

In response to a RATS command, SRTAG2K-D returns FWI parameter (default frame

waiting time used); when SRTAG2K-D needs more time for a command execution, it

requests a frame waiting time extension by responding 0xF2 0xWTX (Request waiting time

= FWI * WTX). If the reader accepts SRTAG2K-D request, it acknowledges by sending the

command 0xF2 0xWTX. The frame waiting time becomes FWI * WTX for the current

command only.

5.5

CRC of the RF frame

The two CRC bytes check the data transmission between the RF host and the SRTAG2K-D.

For the RF frame, the CRC is computed on all the data bits in the frame, excluding parity

bits, SOF and EOF, and the CRC itself.

The CRC is as defined in ISO/IEC 13239. The initial register content shall be 0x6363 and

the register content shall not be inverted after calculation.

5.6

NFC Forum Type 4 Tag protocol

5.6.1

Commands set

SRTAG2K-D command set is built to easily support the NFC Forum Type 4 Tag protocol.

Table 17. S-Block detailed format

b7-b6

b5-b4

0b11

S-Block

0b00: Deselect

0b11: WTX

0: DID field is not present

1: DID field is present

RFU

Table 18. Command set overview

Command name

Brief description

NDEF Tag Application Select

Select the NDEF Tag Application

Capability Container Select

Select the capability container (CC) file using the

Select command

NDEF Select

Select the NDEF file

System File Select

Select the system file

SRTAG2K-D bảng dữ liệu(PDF) 23 Page - STMicroelectronics

SRTAG2K-D bảng dữ liệu(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

bảng dữ liệu tải về

Link URL