R5973AD datasheet(15/38 Pages) STMICROELECTRONICS

tên linh kiện	R5973AD

Giải thích chi tiết về linh kiện	Up to 1.5 A step-down switching regulator for aerospace applications

PDF	38 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

15 / 38 page

DocID027027 Rev 1

15/38

R5973AD

Additional features and protection

6.1

Feedback disconnection

If the feedback is disconnected, the duty cycle increases towards the maximum allowed

value, bringing the output voltage close to the input supply. This condition could destroy the

load.

To avoid this hazardous condition, the device is turned OFF if the feedback pin is left

floating.

6.2

Output overvoltage protection

Overvoltage protection, or OVP, is achieved by using an internal comparator connected to

the feedback, which turns OFF the power stage when the OVP threshold is reached. This

threshold is typically 30% higher than the feedback voltage.

When a voltage divider is required to adjust the output voltage (Figure 15 on page 27), the

OVP intervention will be set at:

Equation 1

Where R1 is the resistor connected between the output voltage and the feedback pin, and

R2 is between the feedback pin and ground.

6.3

Zero load

Due to the fact that the internal power is a PDMOS, no boostrap capacitor is required and so

the device works properly even with no load at the output. In this case it works in burst

mode, with a random burst repetition rate.

VOVP

1.3

R1 R2

--------------------



VFB



R5973AD bảng dữ liệu(PDF) 15 Page - STMicroelectronics