DLP5500AFYA datasheet(21/46 Pages) TI1

21 / 46 page

DLP5500

www.ti.com

DLPS013F – APRIL 2010 – REVISED MAY 2015

9.3 Feature Description

The DLP5500 device consists of 786,432 highly reflective, digitally switchable, micrometer-sized mirrors

(micromirrors) organized in a two-dimensional orthogonal pixel array. Refer to Figure 11 and Figure 13.

Each aluminum micromirror is switchable between two discrete angular positions, –a and +a. The angular

positions are measured relative to the micromirror array plane, which is parallel to the silicon substrate. Refer to

Micromirror Array Optical Characteristics and Figure 14.

The parked position of the micromirror is not a latched position and is therefore not necessarily perfectly parallel

to the array plane. Individual micromirror flat state angular positions may vary. Tilt direction of the micromirror is

perpendicular to the hinge-axis. The on-state landed position is directed toward the left-top edge of the package,

as shown in Figure 13.

Each individual micromirror is positioned over a corresponding CMOS memory cell. The angular position of a

specific micromirror is determined by the binary state (logic 0 or 1) of the corresponding CMOS memory cell

contents, after the mirror clocking pulse is applied. The angular position (–a and +a) of the individual

micromirrors changes synchronously with a micromirror clocking pulse, rather than being coincident with the

CMOS memory cell data update.

Writing logic 1 into a memory cell followed by a mirror clocking pulse results in the corresponding micromirror

switching to the +a position. Writing logic 0 into a memory cell followed by a mirror clocking pulse results in the

corresponding micromirror switching to the – a position.

Updating the angular position of the micromirror array consists of two steps. First, update the contents of the

CMOS memory. Second, apply a micromirror clocking pulse (reset) to all or a portion of the micromirror array

(depending upon the configuration of the system). Micromirror reset pulses are generated externally by the

DLPC200 controller in conjunction with the DLPA200 analog driver, with application of the pulses being

coordinated by the DLPC200 controller.

For more information, see the TI application report DLPA008, DMD101: Introduction to Digital Micromirror Device

(DMD) Technology.

Submit Documentation Feedback

Product Folder Links: DLP5500

DLP5500AFYA bảng dữ liệu(PDF) 21 Page - Texas Instruments