RF65 datasheet(41/72 Pages) ETC2

41 / 72 page

Page 41

RF65

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

ADVANCED COMMUNICATIONS & SENSING

DATASHEET

Rx DATA

(NRZ)

Bit N-x =

Sync_value[x]

Bit N-1 =

Sync_value[1]

Bit N =

Sync_value[0]

DCLK

SyncAddressMatch

Figure 24. Sync Word Recognition

During the comparison of the demodulated data, the first bit received is compared with bit 7 (MSB) of RegSyncValue1 and

the last bit received is compared with bit 0 (LSB) of the last byte whose address is determined by the length of the Sync

word.

When the programmed Sync word is detected the user can assume that this incoming packet is for the node and can be

processed accordingly.

SyncAddressMatch is cleared when leaving Rx or FIFO is emptied.

5.2.3.2. Configuration



Size: Sync word size can be set from 1 to 8 bytes (i.e. 8 to 64 bits) via SyncSize in RegSyncConfig.



Error tolerance: The number of errors tolerated in the Sync word recognition can be set from 0 to 7 bits to via SyncTol.



Value: The Sync word value is configured in SyncValue(63:0).

Note

SyncValue choices containing 0x00 bytes are not allowed

5.2.4. Packet Handler

The packet handler is the block used in Packet mode. Its functionality is fully described in section 5.5.

5.2.5. Control

The control block configures and controls the full chip's behavior according to the settings programmed in the configuration

registers.

RF65 bảng dữ liệu(PDF) 41 Page - List of Unclassifed Manufacturers