UPD6461GS datasheet(39/60 Pages) NEC

39 / 60 page

µPD6461, 6462

4.4 CONTINUOUS INPUT OF COMMAND

Transfer each of the 1-byte, 2-byte, and 2-byte successive commands from a microcontroller to the

µPD6461, 6462

as follows.

To transfer a 1-byte or 2-byte command, or a 2-byte successive command with blinking data changed after a 2-

byte successive command has been transferred, either make CS high once, or transfer 2-byte successive command

end code (FFH:

µPD6461/7FH: µPD6462) at the end of the 2-byte successive command. In the latter case, it is not

necessary to make CS high.

4.4.1 When End Code is Not Used

Example 1-byte command

→ 2-byte successive command → 1-byte command

DATA

CLK

Make CS low once and then back high again.

2nd byte

(D0-D7)

MSB first (LSB first)

2nd byte

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

2-byte successive

command

1st byte

(D0-D7)

1-byte command

(D0-D7)

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

D7-D0

D15-D8

D7-D0

1-byte command

4.4.2 When End Code is Used

Example 1-byte command

→ 2-byte successive command → 1-byte command

DATA

CLK

1-byte command

2nd byte

(D0-D7)

MSB first (LSB first)

2nd byte

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

2-byte successive

command

1st byte

(D0-D7)

1-byte command

(D0-D7)

(D8-D15)

FFH ( PD6461)/

7FH ( PD6462)

(2-byte successive

command end code)

D7-D0

D15-D8

D7-D0

It is not necessary to make CS low and then back high again.

Remark By using the 2-byte successive command end code, the CS pin may remain low. However, it is

recommended to make CS pin high to improve the noise immunity.

UPD6461GS bảng dữ liệu(PDF) 39 Page - NEC

UPD6461GS bảng dữ liệu(HTML) 39 Page - NEC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

bảng dữ liệu tải về

Link URL