16/17

GUIDELINES FOR UPGRADING FROM THE ST92F120 (0.50 µm) TO THE ST92F124...

3.3 HOW TO UPGRADE/RECONFIGURE YOUR ST9 HDS2V2 EMULATOR

The procedure tells you how to upgrade/reconfigure your ST9 HDS2V2 emulator. Be sure you

meet all the prerequisites before starting, otherwise you could damage your emulator by per-

forming this procedure.

1. Ensure that your ST9 HDS2V2 emulator is connected via the parallel port to your host PC

running either Windows ® 95, 98, 2000 or NT ®. If you are reconfiguring your emulator to

be used with a new probe, the new probe must be physically connected to the HDS2V2

main board using the three flex cables.

2. On the host PC, from Windows ®, select Start >Run....

3. Click the Browse button to browse to folder where you installed the ST9+ V6.1.1 Toolchain.

By default, the installation folder path is C:\ST9PlusV6.1.1\... In the installation folder,

browse to the ..\downloader\ subfolder.

4. Locate the ..\downloader\<ST9xxxx-EMU2>\ directory corresponding to the name of the

emulator you want to upgrade/configure.

For example, if you want to reconfigure your ST92F120 emulator to be used with the

ST92F150-EMU2 emulation probe, browse to the ..\downloader\<ST92F150-EMU2>\

directory.

5. Then select the directory corresponding to the version you wish to install (for example, the

V1.01 version is found in ..\downloader\<ST92F150-EMU2>\v1.01\) and select the file

<setup_st9xxxx.bat> (for example, setup_st92f150.bat).

6. Click on Open.

7. Click OK in the Run window. The update will begin. You have simply to follow the instruc-

tions displayed on your PC’s screen.

WARNING: Do not stop the emulator, or the program while the update is in progress! Your

emulator may be damaged!