15/17

GUIDELINES FOR UPGRADING FROM THE ST92F120 (0.50 µm) TO THE ST92F124...

3 UPGRADING AND RECONFIGURING YOUR ST9 HDS2V2 EMULATOR

3.1 INTRODUCTION

This section contains information about how to upgrade your emulator’s firmware or recon-

figure it to support a ST92F150 probe. Once you have reconfigured your emulator to support

a ST92F150 probe you can configure it back to support an other probe (for example a

ST92F120 probe) following the same procedure and choosing the suitable probe.

3.2 PREREQUISITES TO UPGRADING AND/OR RECONFIGURING YOUR EMULATOR

The following ST9 HDS2V2 emulators and emulation probes support upgrades and/or recon-

figuration with new probe hardware:

– ST92F150-EMU2

– ST92F120-EMU2

– ST90158-EMU2 and ST90158-EMU2B

– ST92141-EMU2

– ST92163-EMU2

Before trying to perform the upgrade/reconfiguration of your emulator, you must ensure that

ALL of the following conditions are met:

– The monitor version of your ST9-HDS2V2 emulator is higher than or equal to 2.00. [You can

see which monitor version your emulator has in the Target field of the About ST9+ Visual

Debug window, which you open by selecting Help>About.. from the ST9+ Visual Debug’s

main menu.]

– If your PC is running on the Windows ® NT ® operating system, you must have the admin-

istrator privileges.

– You must have installed the ST9+ V6.1.1 (or later) Toolchain on the host PC connected to

your ST9 HDS2V2 emulator.