HD49235FS datasheet(13/41 Pages) HITACHI

13 / 41 page

HD49235FS

Rev.2, Aug. 1995, page 13 of 41

AMPP: Non-inverting input to the amplifier.

This chip uses a PLL for recovery of the bit clock. A built-in circuit automatically adjusts the free-

running frequency of the PLL, so fewer adjustments are required on the production line. The chip can

be forced to adjust its own free-running frequency whenever power is turned on or the speed is changed

by switching to CLV stop mode. Thus the free-running frequency is always set to the center of the lock

frequency range even if changes occur in the VCO and external circuit constants due to aging.

The principle and usage of automatic adjustment of the free-running frequency will be described below.

a. In automatic adjustment of the VCO free-running frequency, this chip uses the disc stop signal. The

disc stop signal is turned on when the microprocessor writes 0000 in bits ED3, ED2, ED1, and ED0

of register E in the chip’s microprocessor interface. (See section 6, Microprocessor Interface.)

b. When the disc stop signal is turned on, counter (A) in figure 2 becomes a divide-by-98 counter,

switch (A) is connected to the output from the VCO, and switch (B) is connected to digital 0.

At this time, the circuit for the PDOUT1 output is stopped, so the output of the LPF1 connected to

PDOUT1 goes to the fixed DC bias level, which is 1/2 V

DD.

The loop formed by PDOUT2

→ LPF2 → amplifier → VCO → counter (A) now operates to lock

the VCO oscillator frequency to 34.5744 MHz, which is 8 times the standard CD bit rate (4.3218

MHz).

HD49235FS bảng dữ liệu(PDF) 13 Page - Hitachi Semiconductor