S18SP6LP datasheet(27/42 Pages) ETC2

27 / 42 page

Compact Sensors

More information online at

bannerengineering.com

Q23 Series

Q23 and QH23 Specifications

Repeatability

Opposed: 0.13 milliseconds;

Retroreflective and Diffuse: 0.25 milliseconds

FPY High-Speed Plastic Fiber Optic: 25 microseconds

Response time and repeatability specifications are independent of signal strength.

Adjustments

SENSITIVITY control (single-turn, o-ring sealed potentiometer)

Indicators

Sensors except opposed mode emitters have two LEDs:

Green ON steady: dc power ON

Green flashing: output overload

Yellow ON steady: Light Operate (LO), output is energized

Yellow flashing: marginal excess gain (1 - 1.5x), LO output is energized

Emitters have green power “ON” indicator

Construction

Yellow and black ABS housing, with acrylic lenses, completely sealed. Stainless steel mounting bracket and M3

mounting hardware are supplied

Environmental Rating

Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 6, 12, and 13; IEC IP67. Housing materials rated UL 94 V-0

Connections

PVC-jacketed 4-conductor 2 m or 9 m cables, or 4-pin Pico-style 50 mm threaded quick-disconnect (QD) fitting are

available. Mating QD cables are ordered separately. See page 378.

Operating Conditions

Temperature: -20° to +55° C

Relative humidity: 90% at 50° C (non-condensing)

Application Notes

To avoid damage to the sensor caused by static discharge (ESD), use the plastic screwdriver supplied with each

sensor (included in the hardware packet) to adjust the SENSITIVITY control. Otherwise, use a screwdriver with an

insulated handle.

Certifications

Hookup Diagrams

Emitters: DC03 (p. 476)

NPN Models: DC07 (p. 477)

PNP Models: DC08 (p. 477)

(cont’d)

Q23 and QH23 Specifications (cont’d)

S18SP6LP bảng dữ liệu(PDF) 27 Page - List of Unclassifed Manufacturers