LM6172QML

SNOSAR4A – DECEMBER 2010 – REVISED OCTOBER 2011

www.ti.com

LM6172 (±15V) ELECTRICAL CHARACTERISTICS

DC PARAMETERS

(1) (continued)

The following conditions apply, unless otherwise specified.

Sub-

Symbol

Parameter

Conditions

Notes

Min

Max

Units

groups

12.5

-12.5

V

1

12

-12

V

2, 3

Output Swing

6.0

-6.0

V

1

5.0

-5.0

V

2, 3

60

mA

1

50

mA

2, 3

Output Current (Open Loop)

-60

mA

1

-50

mA

2, 3

8.0

mA

1

Supply Current

Both Amplifiers

9.0

mA

2, 3

(3)

The open loop output current is specified by measurement of the open loop output voltage swing using 100

Ω output load.

AC PARAMETERS

(1)

The following conditions apply, unless otherwise specified.

Sub-

Symbol

Parameter

Conditions

Notes

Min

Max

Units

groups

SR

Slew Rate

1700

V/µS

4

3nS Rise & Fall time

GBW

Unity-Gain Bandwidth

80

MHz

4

(1)

Pre and post irradiation limits are identical to those listed under AC and DC electrical characteristics. These parts may be dose rate

sensitive in a space environment and demonstrate enhanced low dose rate effect. Radiation end point limits for the noted parameters

are specified only for the conditions as specified in Mil-Std-883, Method 1019.5, Condition A.

(2)

See AN0009 for SR test circuit.

(3)

Slew Rate measured between ±4V.

(4)

See AN0009 for GBW test circuit.

DC DRIFT PARAMETERS

(1)

The following conditions apply, unless otherwise specified.

Delta calculations performed on QMLV devices at group B , subgroup 5.

Sub-

Symbol

Parameter

Conditions

Notes

Min

Max

Units

groups

Input Offset Voltage

-0.25

0.25

mV

1

Input Bias Current

-0.50

0.50

µA

1

Input Offset Current

-0.25

0.25

µA

1

(1)

Pre and post irradiation limits are identical to those listed under AC and DC electrical characteristics. These parts may be dose rate

sensitive in a space environment and demonstrate enhanced low dose rate effect. Radiation end point limits for the noted parameters

are specified only for the conditions as specified in Mil-Std-883, Method 1019.5, Condition A.

6

Submit Documentation Feedback

Copyright © 2010–2011, Texas Instruments Incorporated

Product Folder Links: LM6172QML